How to protect your windshield from chips and scratches?
During the operation of the car, the windshield receives microdamage in the form of small scratches from the wipers, especially if you use them in the winter, chips and cracks from pebbles, etc. All this not only significantly reduces the transparency and quality of vision, but also leads to fatigue of the material and cracking of the glass even from small loads.
The expediency of using protective and tint films
One of the ways to protect the wind glass https://vitavto.kiev.ua/services/zaschita-lobovogo-stekla/ is car tinting or the use of special protective films. At the same time, quality coatings such as ClearPlex and Llumar are quite expensive. But, as practice shows, their use is much more expedient, both from a technical and financial point of view, than replacing a windshield for the following reasons:
- The cost of a high-quality protective or tint film is comparable to the most cheap non-original glasses. At the same time, both the strength and durability of such glasses leaves much to be desired. It also significantly increases the risk of injury to the driver and passenger in the front seat, even in minor collisions. In addition, the higher cost of installing a new glass should be taken into account than the stickers of a tinted protective film;
- An important factor is the technical component. The spatial rigidity of the car body of the front of the vehicle is more than 20% dependent on the correct installation of the windshield. When replacing, the technology must be impeccably observed, even a small imprint on the end can violate the tightness during gluing, and an error in maintaining gaps per millimeter can cause cracks during sharp maneuvers when driving.
The principle of operation and technical characteristics
A protective or tint film on a car, for example, ClearPlex (protective), is applied to the outside of the windshield. At the moment of impact with crushed stone, the point of impact deformation is distributed over a large area, which significantly reduces the likelihood of critical damage.
When choosing a film, you need to pay attention to the following parameters:
- Transparency level . The characteristic is important, both for tint films and for protective ones. Gradation is indicated as a percentage of light transmission from a completely transparent glass;
- Optical optimization. This parameter describes the absence of optical distortion;
- Durability. It is described by a combination of such characteristics as the time of absence of yellowing, flaking (formation of bubbles) guaranteed by the manufacturer under intense external influence of sunlight, humidity and temperature changes;
improves driving comfort, especially in southern regions with more intense sunlight. In addition, the intensity of burnout of interior materials is reduced, and the need for intensive operation of climate systems is also reduced. Since the heating of the cabin is much slower.