A plate-rotor (blade-type) vacuum pump is one of the most extensive types of pumps in industry. They can be installed on packing machines, at other woodworking workbenches, at the system for cutting blanks at the CNC, at milking machines and asenizational technology. The design is simple, and you can get married for a long time, because you need regular work. Additional information about the types of blades and their analogues can be found on the website pumpvane.com.ua .
Budova
In the middle of the cylindrical body (stator), the rotor wraps around, and the rotation is eccentric. The rotors have radial grooves in which the plate blades can move. The two center-mounted blades are suspended and pressed against the stator plate, which is distributed between the rotor and the housing on the chamber.
The principle of robotics
Through the eccentricity of the skin chamber, the air is wrapped around the outside, the gas is sucked through the inside nozzle, and the steam is squeezed, and the compressed gas is squeezed at the ends. If the blades lie down to the stator and there is less clearance at the ends, then there is less vacuum and a pump.
Oil and dry pumps
- Oil (oil pinch): oil squeezes the shoulder blades, squeezes the gaps, and removes heat. I give you the best vacuum, but I need to check the oil level of the oil cooler.
- Dry (oil-free): graphite blades are self-cleaning, there is no oil. Such pumps are popular in the poligraphy of such grubby promiscuity, such an oil fog.
I can't wait
- Shoulder blades. Upper vitrate element of dry pumps. The graph is gradually erased, and the shoulder blade is wider. The resource should be stored in the robot purity mode inside.
- Filtry. The bottom filter uses a saw pump, the bottom (for dry pumps) uses a graphite saw, and the oil filter uses an oil mist.
- Sideships of that ravine shaft. They are removed later, however, before the rotor contacts with the stator.
- The oil (at the oil pumps) is behind the virobnik graph.
Why don't you check for breakdowns
The blade can be worn out in the groove of the rotor. You can squeeze the stator, and lock the blades, and the set of blades will have to plug the housing, and then the pump. That shoulder blade takes about an hour of scheduled maintenance, and I take it as a set, but the width has come close to the limit set by the counter.
Yak to increase the pump resource
I've been drinking too much, Vologda, and I've been drinking too much. That's why I've been cleaning and cleaning behind the counter, and in the saw shops — more often. The pump is not responsible for dampening the bottom of the steam: condensate ruining graphite blades. It is also important that the pump has early access inside for