In the assortment of a modern builder there are many helpers. Each tool is designed not only to facilitate work, but also to improve the quality of the result. Modern vibrating plates are used for soil compaction and construction materials. Sufficiently versatile, it can be used for other construction and installation works on the site.
Preparation before use
Each technique has its own unique features of operation. Any manufacturer will strongly recommend that you read the instructions carefully and in detail. In it you can get answers to almost all questions of interest. But, a construction tool, regardless of the manufacturer, also has universal preparatory procedures:
- Be sure to check the oil level before starting the engine.
- Fill up the gas tank so you don't have to refuel.
- Make sure the tool is on the work surface.
- Start the engine and let it warm up a bit.
- After finishing work, check the condition of the air filter.
The easiest way to work with a vibrating plate with an electric motor. It requires minimal preparatory work. The main thing is that the power cord is long enough, and care must be taken to ensure that the wire does not fall under the vibrating plate. Try to exclude situations when the vibrating plate is put into operation on a solid foundation.
Features of starting and stopping the tool
It is worth repeating, if the master has an electric tool in his hands, working with it does not present additional difficulties. The presence of an internal combustion engine requires a more careful attitude on the part of the operator. The most important and important actions will be the following manipulations:
- open the fuel valve under the gas tank to supply fuel;
- close carburetor choke before starting;
- you can skip the previous action if the engine is already hot;
- raise the carburettor idle slightly;
- turn on the ignition and start the engine with a sharp movement of the hand.
If the equipment is well maintained and not in a state of critical wear, the engine starts on the first, maximum third attempt. In the cold season, experts recommend pulling the cord several times before turning on the ignition. So that a little fuel enters the combustion chamber, and begins to evaporate there. This preparatory work greatly facilitates starting the engine.
During the operation of the vibrating plate, it is necessary to strictly observe safety measures. Avoid getting feet, foreign objects under the working part of the tool.
